Installing front belt lock
WARNING: This page is about a different car, the 2016 Porsche Macan and 2015 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.
Information
Always replace the fastening screws on the seat-belt buckle after customer service and reworking. The micro self-locking screws must not be treated, greased or loosened and then screwed on again.
Information
When routing the wire harness for the front seat-belt buckle, ensure that it is routed without tension.
- Tighten fastening screw -3-
until secure Tightening torque 50 Nm (37 ft lb.)
.WARNING: Incorrect handling of safety bolts
- Danger of injury
- Loss of torque
→ Always use new fastening screws and nuts following removal.
→ Observe specified tightening torques.
→ Carry out a visual inspection of all re-used parts.
- Connect electric plug connection -2- (-A- ) until the connector engages securely.
- Fit two fixing clips -1- .