Installing rear apron

WARNING: This page is about a different car, the 2016 Porsche Macan and 2015 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.

Installation is performed in reverse order. Pay particular attention to the following:

Before installation, an adhesive strip → Teflon tape must be affixed at the transition points to the tail lights on the rear apron to prevent damage.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Tighten fastening screws securing rear apron to wing using Tightening torque 2 Nm (1.5 ft lb.) torque screwdriver Nr.89 Pos.5 .
Tighten fastening screws on retaining strip to Tightening torque 2 Nm (1.5 ft lb.) .
Tighten fastening screws on the underbody to Tightening torque 2 Nm (1.5 ft lb.) .
Tighten fastening screws on the wheel housing liners to Tightening torque 2 Nm (1.5 ft lb.) .
Tighten fastening screws on guide pins for the tailgate to Tightening torque 10 Nm (7.5 ft lb.) .
Remove adhesive strip.