Installing front apron
WARNING: This page is about a different car, the 2016 Porsche Macan and 2015 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.
Installation is performed in reverse order. Pay particular attention to the following:
- Tighten fastening screws securing front apron to inner lock carrier to the specified tightening torque. Tightening torque 8 Nm (6 ft lb.)
- Tighten fastening screws securing front apron to retaining strip to the specified tightening torque. Tightening torque 2 Nm (1.5 ft lb.)
- Tighten fastening screws securing front apron to outer lock carrier to the specified tightening torque. Tightening torque 8 Nm (6 ft lb.)
- Tighten fastening screws securing front apron to lock carrier at the bottom to the specified tightening torque. Tightening torque 2 Nm (1.5 ft lb.)
- Tighten fastening screws securing front apron to lock carrier at the sides to the specified tightening torque. Tightening torque 2 Nm (1.5 ft lb.)
- Tighten fastening screws securing wheel housing liner to lock carrier to the specified tightening torque. Tightening torque 2 Nm (1.5 ft lb.)