LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2017 >> Macan S >> Repair and Diagnosis >> External Pages >> Different car >> Section 603 (51 - Body Center, Roof, Frame - (95B) MACAN) >> WM 511355 Replacing A-Pillar Reinforcement >> Subsequent Work

Subsequent Work

WARNING: This page is about a different car, the 2018 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install A-pillar. Refer to 511255 REPLACING A-PILLAR .
  2. Install front part of outer side member. Refer to 514555 REPLACING OUTER SIDE MEMBER .

Subsequent Work For Body Repairs (Without Straightening System) 

  1. Clean joint areas and sheetmetal flanges with a wire brush.
  2. Prime joint areas and sheetmetal flanges with 2K primer.
  3. Restore standard seal with body sealant. Refer to WM 5X00IN SEAM SEALS . Also seal the repair area carefully.
  4. Paint repair area and adjacent surfaces, if necessary.
  5. Restore standard underbody protection with underbody sealant. Refer to WM 5X00IN UNDERBODY PROTECTION .
  6. Apply standard cavity preservation. Refer to WM 5X00IN CAVITY PRESERVATION . Also apply cavity preservation to the repair area.
  7. Install removed accessories in the repair area.

Model year as of 2014

scientia non olet · About LEMON Manuals