Installing Side Section Lower Part

WARNING: This page is about a different car, the 2018 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.

Information:

Before final assembly, make sure you fully understand all the work steps involved and carry out a trial assembly without applying adhesive .
The bonding process can only be carried out reliably when a smooth and swift sequence of operations is guaranteed .
Do not begin bonding work until all materials and tools necessary for later repair work are available .

Apply adhesive Application depth: 3.0 mm
Working with body structural adhesive. Refer to WM 5X00IN WORKING WITH BODY STRUCTURAL ADHESIVE 000.043.206.30 , WM 5X00IN WORKING WITH BODY STRUCTURAL ADHESIVE PAH.071.781.00 .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Applying adhesive
Resistance spot-weld the side section lower part.
1. 2.1. Plug-weld area -A - using inert gas.
Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Installing side section lower part