LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2017 >> Macan S >> Repair and Diagnosis >> External Pages >> Different car >> Section 602 (53 - Body Rear - (95B) MACAN) >> WM 530555 Replacing Rear Closing Panel >> Subsequent Work >> Subsequent Work For Body Repairs (Without Straightening System)

Subsequent Work For Body Repairs (Without Straightening System)

WARNING: This page is about a different car, the 2018 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.
  1. Clean joint areas and sheet metal flanges with a wire brush.
  2. Prime joint areas and sheet metal flanges with 2K primer.
  3. Restore standard seal with body sealant; Refer to WM 5X00IN SEAM SEALS .

    Also seal the repair area carefully.

  4. Paint repair area and adjacent surfaces, if necessary.
  5. Restore standard underbody protection with underbody sealant; Refer to WM 5X00IN UNDERBODY PROTECTION .
  6. Apply standard cavity preservation; Refer to WM 5X00IN CAVITY PRESERVATION , Also apply cavity preservation to the repair area.
  7. Install removed accessories in the repair area.

Model year as of 2014

scientia non olet · About LEMON Manuals