Installing Lock Carrier
WARNING: This page is about a different car, the 2018 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.
Installation is performed in reverse order. Pay particular attention to the following:
- Tighten fastening screws securing bracket to body to the specified torque. Tightening torque 55 Nm (41 ftlb.)
- Replace sealing rings on the refrigerant lines and tighten fastening screws for the refrigerant lines at the connection point to the condenser to the specified torque. Tightening torque 8 Nm (6 ftlb.)
- Tighten fastening screws securing supports to lock carrier to the specified torque. Tightening torque 5 Nm (3.5 ftlb.)
- Tighten fastening screw on holder for garage door opener control unit to the specified torque. Tightening torque 6 Nm (4.5 ftlb.)
- Tighten top fastening screws securing wing strut to lock carrier to the specified torque. Tightening torque 9.7 Nm (7.5 ftlb.)
- Tighten top fastening screws securing transverse strut to body to the specified torque. Tightening torque 9.7 Nm (7.5 ftlb.)
- Tighten side fastening screws securing transverse strut to body to the specified torque. Tightening torque 10 Nm (7.5 ftlb.)
- Tighten side fastening screws on the front retaining strips to the specified torque. Tightening torque 9.7 Nm (7.5 ftlb.)
- Tighten fastening screws securing headlight mounting to body to the specified torque.
- Tighten screw-type clamp securing throttle-housing cover to pressure pipe to the specified torque. Tightening torque 5.5 Nm (4 ftlb.)