LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2017 >> Macan S >> Repair and Diagnosis >> External Pages >> Different car >> Section 601 (50 - Body Front - (95B) MACAN) >> WM 503819 Removing And Installing Lock Carrier Side Section At The Right >> Installing Lock Carrier Side Section At The Right

Installing Lock Carrier Side Section At The Right

WARNING: This page is about a different car, the 2018 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.

Installation is performed in reverse order. Pay particular attention to the following: 

  1. Tighten fastening screws securing wing strut to lock carrier to the specified torque. Tightening torque 9.7 Nm (7.5 ftlb.) 
  2. Tighten fastening screws securing upper part of lock carrier to lock carrier to the specified torque. Tightening torque 9.7 Nm (7.5 ftlb.) 
  3. Tighten fastening screw securing support to lock carrier to the specified torque. Tightening torque 5 Nm (3.5 ftlb.) 
  4. Tighten fastening nut securing support to chassis subframe to the specified torque. Tightening torque 23 Nm (17 ftlb.) 
  5. Tighten fastening screws securing lock carrier to radiator to the specified torque. Tightening torque 4.5 Nm (3 ftlb.) 
  6. Tighten fastening screws securing radiator holder to lock carrier to the specified torque. Tightening torque 4.5 Nm (3 ftlb.) 
scientia non olet · About LEMON Manuals