Installing Lock Carrier Side Section At The Left
WARNING: This page is about a different car, the 2018 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.
Installation is performed in reverse order. Pay particular attention to the following:
- Tighten fastening screws securing wing strut to lock carrier to the specified torque. Tightening torque 9.7 Nm (7.5 ftlb.)
- Tighten fastening screws securing upper part of lock carrier to lock carrier to the specified torque. Tightening torque 9.7 Nm (7.5 ftlb.)
- Tighten fastening screws securing radiator bracket to lock carrier to the specified torque. Tightening torque 4.5 Nm (3.25 ftlb.)
- Tighten fastening screws securing refrigerant line holder to lock carrier to the specified torque. Tightening torque 2.5 Nm (2 ftlb.)
- Tighten fastening screw securing refrigerant line holder to dual clip for refrigerant lines to the specified torque. Tightening torque 4.5 Nm (3.25 ftlb.)
- Tighten fastening nut securing support to chassis subframe to the specified torque. Tightening torque 23 Nm (17 ftlb.)
- Tighten fastening screw securing support to lock carrier to the specified torque. Tightening torque 5 Nm (3.5 ftlb.)
- Tighten fastening screw securing lock carrier to radiator to the specified torque. Tightening torque 4.5 Nm (3.25 ftlb.)