Securing Lock Carrier

Information: 

Check that the fixing clips are not bent or broken.

Check that all fixing clips are positioned fully and correctly.

Replace damaged or missing clips with new ones.

The lock carrier is secured in reverse order. Pay particular attention to the following: 

1. Tighten fastening screws for coolant line to the specified torque. Tightening torque 5 Nm (3.5 ftlb.) 
2. Tighten fastening screw securing refrigerant line bracket to dual clip to the specified torque. Tightening torque 4.5 Nm (3.25 ftlb.) 
3. Tighten fastening screws securing supports to lock carrier to the specified torque. Tightening torque 5 Nm (3.5 ftlb.) 
4. Tighten fastening screws securing bracket to body to the specified torque. Tightening torque 55 Nm (41 ftlb.) 
5. Tighten fastening screw on holder for garage door opener control unit to the specified torque. Tightening torque 6 Nm (4.5 ftlb.) 
6. Tighten top fastening screws securing wing strut to lock carrier to the specified torque. Tightening torque 9.7 Nm (7.5 ftlb.) 
7. Tighten side fastening screws securing transverse strut to body to the specified torque. Tightening torque 10 Nm (7.5 ftlb.) 
8. Tighten top fastening screws securing transverse strut to body to the specified torque. Tightening torque 9.7 Nm (7.5 ftlb.) 
9. Tighten side fastening screws on the front retaining strips to the specified torque. Tightening torque 9.7 Nm (7.5 ftlb.) 
10. Tighten fastening screws securing headlight mounting to body to the specified torque.
11. Tighten screw-type clamp securing throttle-housing cover to pressure pipe to the specified torque. Tightening torque 5.5 Nm (4 ftlb.)