Removing Side Section Lower Part

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Information 

Loosen connection points on one side only. Do not damage the sheet-metal panel underneath.

1. Drill out spotwelds using spotweld drill; see Gr. 2.4; Workshop Equipment Manual Nr.129  .
   1. 1.1. Drill out spotweld -A-  from the inside.

      Courtesy of PORSCHE CARS NORTH AMERICA, INC.

2. Heat the marked bonding surfaces.
   1. 2.1. Make a sufficient gap between the side section -1-  and side section lower part -2-.
   2. 2.2. Remove side section lower part.

      Courtesy of PORSCHE CARS NORTH AMERICA, INC.