Installing Cover For Centre Underbody

Installation is performed in reverse order. Pay particular attention to the following: 

1. Tighten fastening screws to Tightening torque 2.5 Nm (1.75 ft lb.)  until secure. Torque screwdriver Nr.89 Pos.5 
2. Tighten fastening screws to Tightening torque 3.5 Nm (2.5 ft lb.)  until secure.
3. Tighten fastening nuts to Tightening torque 2.5 Nm (1.75 ft lb.)  until secure.