Removing Outer B-Pillar

Fig 1: Outer B-Pillar Component Location

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Information 

Only make cuts in the top plate. Make sure not to damage the plate underneath when doing this.

Information 

Mark cuts E, F and G  in accordance with the new part. Make sure to leave an overlap of approx. 3 cm with respect to the body.

1. Mark and make cuts.
   • Distance: 23 mm 
   • Distance: 75 mm 
   • Distance: 120 mm 

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Information 

   Loosen connection points on one side only. Do not damage the sheet-metal panel underneath.

2. Drill out spotwelds using spotweld drill;

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

3. Heat bonding areas.
   1. 3.1. Remove B-pillar.

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.