Reading And Writing Values
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2016 Porsche Panamera, 2015 Porsche Panamera, 2014 Porsche Panamera, 2013 Porsche Panamera, and 2012 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.
NOTIFICATION
Voltage drop
- Risk of irreparable damage to control unit
- Risk of damage to control unit
- Fault entries in the control unit
- Coding in the control unit is aborted
- Malfunctions in control unit, even during programming
→ Prior to disconnecting the control unit, switch off ignition and remove ignition key.
→ Ensure that the power supply is not interrupted during programming.
→ Connect a battery charger with a current rating of at least 90 A to the vehicle battery.
Information
The PIWIS Tester instructions take precedence since the description may be different with later Tester releases.
The procedure described here has been structured in general terms. Different text or additional information may appear on the PIWIS Tester.
- Connect the Porsche System Tester to the vehicle and start the System Tester. Switch on ignition and press [F12] to continue.
- Select the vehicle type. The diagnostic application starts.
- Select the Adaptive cruise control control unit in the overview.
- Select Maintenance/repairs.
- Select Control unit replacement and press [F12]
- Read data and press [F12]
- Press [F12] to start reading out data.
- Check the chassis number and press [F12].
- Switch off ignition and replace control unit.
> 278519 REMOVING AND INSTALLING CONTROL UNIT FOR DISTANCE MEASURING SENSOR
- Switch on ignition. Select the Write data menu (procedure described above), press [F12] and then press [F8] to start installing the data that was read out.
- The System Tester displays the message Data has been written. Press [F12] to continue.
- Read out fault memory and erase it if necessary.