Subsequent Work For Battery
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2016 Porsche Panamera, 2015 Porsche Panamera, 2014 Porsche Panamera, 2013 Porsche Panamera, and 2012 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.
- Install control unit for voltage transformer for Start/Stop, if used.
> 270419 REMOVING AND INSTALLING VOLTAGE TRANSFORMER FOR START/STOP - section on "Installing"
Information
The AGM (Absorbent Glass Mat) battery is a maintenance-free, sealed battery.
Serial number and part number on battery
- This battery must not be opened. If the battery is opened, it must be replaced.
- There is a serial number -A- and a part number -B- on the top right-hand side of the battery.
- After replacing the battery, the serial number and part number as well as the battery size and manufacturer must be entered using the PIWIS Tester under: Gateway/Maintenance/repairs/Change battery.
- The battery size and battery manufacturer must also be entered when changing the battery.
- If a new battery was installed, the new battery must be documented in the gateway control unit using > 9818 -PIWIS Tester II .
- Carry out work instruction after disconnecting the battery.
- Fit tool kit tray.
- Close the luggage compartment floor.