Component Overview
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2016 Porsche Panamera, 2015 Porsche Panamera, 2014 Porsche Panamera, 2013 Porsche Panamera, and 2012 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.
Information
The oil pressure control valve is located on the right side of the oil guide housing, at the front next to the oil filter.
Installation position
| 1 | Oil pressure control valve flange |
| 2 | Engine oil filter |
| 3 | Generator |
| 4 | Oil pan |
Oil guide housing with accessories
| 1 | Screw, M6 x 20 |
| 2 | Joint flange |
| 3 | Sealing ring |
| 4 | Oil guide housing to lower part of crankcase - aluminum screw; always use new aluminum screws |
| 5 | Oil level sensor |
| 6 | Oil level sensor to oil guide housing (steel screw) |
| 7 | Timing-case cover to oil guide housing - aluminum screw; always use new aluminum screws |
Oil pump
| 1 | Oil pump |
| 2 | Screw, M8 x 22; replace |
| 3 | Oil pump sprocket |
| 4 | Cap screw, M36 |
| 5 | Solenoid valve (oil pressure control valve) |
| 6 | Sealing rings (grease before fitting) |
| 7 | Dowel sleeve |
| 8 | Screw, M6 x 45 |
| 9 | Sprocket cover |
| 10 | Screw, M6 x 16 |
| 11 | Drive chain |
Oil pressure control valve and tool
| 1 | Screw, M6 x 20 |
| 2 | Joint flange with sealing ring |
| 3 | Cap screw, M36 |
| 4 | Oil sealing ring with engine oil |
| 5 | Solenoid valve/oil pressure control valve |
| 6 | Special socket > 9753 - socket-wrench insert |
| 7 | Puller > 9235 - relay puller |