Model Values
WARNING: This page is about a different car, the 2018 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.
| Location | Description | Type | Basic value | Tolerance 1 | Tolerance 2 |
|---|---|---|---|---|---|
| Minimum processing temperature | 000.043.206.30 | Minimum temperature | 15°C | ||
| Maximum processing temperature | 000.043.206.30 | Maximum temperature | 35°C | ||
| Optimal processing temperature | 000.043.206.30 | Minimum temperature | 18°C | ||
| Optimal processing temperature | 000.043.206.30 | Maximum temperature | 23°C | ||
| Structural bonding | 000.043.206.30 | Processing time at 15 °C | 75 min | ||
| Structural bonding | 000.043.206.30 | Processing time at 18 °C | 70 min | ||
| Structural bonding | 000.043.206.30 | Processing time at 20 °C | 65 min | ||
| Structural bonding | 000.043.206.30 | Processing time at 23 °C | 60 min | ||
| Structural bonding | 000.043.206.30 | Processing time at 25 °C | 55 min | ||
| Structural bonding | 000.043.206.30 | Processing time at 30 °C | 45 min | ||
| Structural bonding | 000.043.206.30 | Processing time at 35 °C | 35 min | ||
| Length of adhesive bead | Length | 10 cm | |||
| Applying adhesive | Spread out evenly | Application depth | 0.5 mm | ||
| Bead of adhesive | Application depth | 3 mm | |||
| Maximum layer thickness | Layer thickness | 1 mm | |||
| Minimum hardening temperature | 000.043.206.30 | Minimum temperature | 18°C | ||
| Maximum hardening temperature | 000.043.206.30 | Maximum temperature | 80°C | ||
| Assembly strength | 000.043.206.30 | Hardening time at 18 °C | 12 h | ||
| Assembly strength | 000.043.206.30 | Hardening time at 60 °C | 35 min | ||
| Endurance strength | 000.043.206.30 | Standing time at 18 ° C | 96 h | ||
| Primer | Flash-off time | 5 min |