Removal And Installation: Installation
WARNING: This page is about a different car, the 2018 Land Rover Range Rover, 2017 Land Rover Range Rover, and 2016 Land Rover Range Rover. However, it is still accessible from the selected car via links, so may be relevant.
-
NOTE: Keep the coolant expansion tank vertically.
Raise the coolant expansion tank minimum 110mm from its original position.
- Fill the cooling system, keeping coolant to the upper level mark of the expansion tank, until a steady stream of coolant is seen returning to the tank.
Torque Specification: 2.8 Nm
-
CAUTION: Make sure the coolant level remains above the "COLD FILL RANGE" lower level mark.
Check and top up the cooling system as required.