Completing Reconditioned Engine
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2016 Porsche Panamera, 2015 Porsche Panamera, 2014 Porsche Panamera, 2013 Porsche Panamera, and 2012 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.
Information
- Some modifications are required in order to replace the old, removed engine with a new one .
- Starting point for conversion work: Old engine is secured to assembly support and the new one is in the transport cradle.
- At higher mileages, components (coolant hoses, clips, etc.) must be checked for damage and replaced if necessary.
- Seals must be checked and replaced if necessary.
Information
For tightening torques, tightening sequence and assembly overview, see → 1001IN TIGHTENING TORQUES, TIGHTENING SEQUENCES, ASSEMBLY OVERVIEWS
Information
Tightening torque, tightening sequence and assembly overview. → 3X00IN TIGHTENING TORQUES, TIGHTENING SEQUENCE AND ASSEMBLY OVERVIEW
- Remove numerous transport stoppers on water and vacuum connection pieces on the new engine.
- Re-fit poly-V-belt and poly-V-belt for compressor. → 137819 REMOVING AND INSTALLING DRIVE BELT
- Re-fit belt tensioner for compressor. → 137319 REMOVING AND INSTALLING BELT TENSIONER
- Re-fit tensioner and deflection roller. → 137319 REMOVING AND INSTALLING BELT TENSIONER
- Re-fit air-conditioning compressor. → 873419 REMOVING AND INSTALLING AIR-CONDITIONING COMPRESSOR
- Re-fit the drive plate. → 136319 REMOVING AND INSTALLING DRIVE PLATE FOR TORQUE CONVERTER
- Re-fit oxygen sensors upstream of catalytic converter. → 246919 REMOVING AND INSTALLING OXYGEN SENSOR UPSTREAM OF CATALYTIC CONVERTER
- Check that all lines and hoses between the engines have been re-fitted and no components have been forgotten.