LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2017 >> Macan GTS >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 13 - Engine - CRANKGEAR, Pistons -- (95B) MACAN >> WM 137419 Removing And Installing Sealing Ring For Crankshaft Pulley (MACAN Only) >> Removing Sealing Ring For Crankshaft Pulley

Removing Sealing Ring For Crankshaft Pulley

  1. Pressure piece T10368  must be screwed on. → Pressure piece -T10368- 
    G11980362

    Pressure piece -T10368- 

  2. Pull off sealing ring using puller hook T40274  . → Pulling off sealing ring 
    G11980363

    Pulling off sealing ring 

    NOTE:
    • If the joint flange on the pulley or the surface on the crankshaft stub is slightly rusted, polish the rust off with a special polishing pad. 
    • If there is bad corrosion or deep grooves, replace these components. 
  3. Clean running and sealing surfaces.
scientia non olet · About LEMON Manuals