LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2017 >> Macan GTS >> Repair and Diagnosis >> Body & Frame >> Exterior/Interior Trim >> 66 Exterior Equipment -- (95B) MACAN >> WM 669419 Removing And Installing C-Pillar Cover (Except MACAN Sport Edition) >> Removing C-Pillar Cover

Removing C-Pillar Cover

NOTE:
  • The number of fastening screws, fixing clips, plug connections, holders and trim panels can vary depending on equipment  .
  • The illustrations for removing and installing the drive mechanism are shown only on one equipment variant and may differ from the actual equipment variant  .
  • Some steps must be carried out automatically  .
  • Some of the repair illustrations show only one side of the vehicle  .
  1. Unscrew screw -1-  .
  2. Loosen rubber seal -2-  on the cover.
  3. Unscrew screws -3-.
    G11981466

    Loosening rubber seal, unscrewing screws 

  4. Slide the cover -1-  down slightly -arrow A-  , detach it from the door and then guide it up and out -arrow B-  .
    G11981467

    Removing C-pillar cover 

scientia non olet · About LEMON Manuals