LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2017 >> Macan Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 468 (Auxiliary Climate Control - TDV6 3.0L Diesel/TDV8 4.4L Diesel/V6 S/C 3.0L Petrol/V8 N/A 5.0L Petrol/V8 S/C 5.0L Petrol -- Range Rover/L405) >> Auxiliary Climate Control - TDV6 3.0L Diesel / V6 S/C 3.0L Petrol / V8 N/A 5.0L Petrol / V8 S/C 5.0L Petrol >> Fuel Fired Booster Heater Coolant Changeover Valve >> Removal And Installation >> Removal

Removal And Installation: Removal

WARNING: This page is about a different car, the 2018 Land Rover Range Rover and 2017 Land Rover Range Rover. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Before disconnecting any components, make sure the area is clean and free from foreign material. When disconnected all openings must be sealed.
NOTE: This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
  1. Disconnect the startup battery ground cable.

    Refer to: SPECIFICATIONS .

  2. Remove the Fuel Fired Booster Heater (FFBH).

    Refer to: FUEL FIRED BOOSTER HEATER .

  3. CAUTION: Be prepared to collect escaping coolant.
    G11701760
    • Release the coolant hose.
    • Disconnect the FFBH coolant changeover valve electrical connector.
  4. G11701761

    Remove the FFBH coolant changeover valve.

scientia non olet · About LEMON Manuals