LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2017 >> Macan Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 354 (Engine Cooling - INGENIUM I4 2.0L Petrol -- Discovery Sport/L550) >> Engine Cooling - INGENIUM I4 2.0L Petrol >> Diagnosis And Testing >> Engine Cooling >> Symptom Chart

Symptom Chart

WARNING: This page is about a different car, the 2018 Land Rover Discovery Sport. However, it is still accessible from the selected car via links, so may be relevant.
SYMPTOM POSSIBLE CAUSES ACTION
Coolant loss
  • Coolant leak
  • Coolant hose damaged
  • Coolant hose clamp loose/damaged
  • Radiator leaking/damaged
  • Coolant pump seal failed
  • Heater core leaking/damaged
  • Seal/gasket leaking
  • Engine casting leaking
  • Engine core plugs leaking
  • Check for coolant leaks. Perform a cooling system pressure test. Rectify as necessary
Overheating
  • Coolant level low
  • Coolant contaminated
  • Coolant leak
  • Thermostat stuck closed
  • Radiator airflow obstructed
  • Cooling fan inoperative
  • Check the coolant level. Rectify as necessary
  • Check the condition of the coolant. Rectify as necessary
  • Check for coolant leaks. Perform a cooling system pressure test. Rectify as necessary
  • Check the operation of the thermostat. Rectify as necessary
  • Check the radiator for obstructions. Rectify as necessary
  • Check the operation of the cooling fan. Rectify as necessary
Engine not reaching normal temperature
  • Thermostat stuck open
  • Check the operation of the thermostat. Rectify as necessary
Cooling fan operating at maximum speed - Engine not running
NOTE: Circuit reference - PWM -
  • Cooling fan control module PWM signal circuit short circuit to ground, short circuit to power, open circuit, high resistance
  • Refer to the appropriate system wiring diagram and check the cooling fan control module PWM signal circuit for short circuit to ground, short circuit to power, open circuit, high resistance. Repair the wiring harness as necessary
Cooling fan is stationary - Engine running
NOTE: Circuit reference - IGN -
  • Cooling fan control module ignition signal circuit short circuit to ground, short circuit to power, open circuit, high resistance
  • Refer to the appropriate system wiring diagram and check the cooling fan control module ignition signal circuit for short circuit to ground, short circuit to power, open circuit, high resistance. Repair the wiring harness as necessary