LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2017 >> Macan Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 316 (96 - Lights, Lamps, Switches, Interior -- 911 CARRERA (991)) >> WM 966255 Replacing Remote Control (All Models) >> Replacing Remote Control

Replacing Remote Control

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2019 Porsche 911, 2018 Porsche 911, 2017 Porsche 911, 2016 Porsche 911, and 2015 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Information 

All remote controls (keys) are required for teaching a DME, front-end electronics (front BCM), rear-end electronics (rear BCM), electronic steering lock (ELV) control unit or remote controls (keys) for example.

Remote controls (keys) that are not taught during this teaching procedure will no longer be recognised by the vehicle.

NOTE: Voltage drop
  • Risk of irreparable damage to control unit
  • Risk of damage to control unit
  • Fault entries in the control unit
  • Coding in the control unit is aborted
  • Malfunctions in control unit, even during programming

→ Prior to disconnecting the control unit, switch off ignition and remove ignition key.

→ Ensure that the power supply is not interrupted during programming.

→ Connect a battery charger with a current rating of at least → Nominal value: 40 A  to the vehicle battery.

The PIWIS Tester II 9818  instructions take precedence since the description may be different with later Tester releases.

The procedure described here has been structured in general terms. Different text or additional information may appear in PIWIS Tester II 9818  .

  1. Connect the Porsche System Tester to the vehicle and start the System Tester. Switch on ignition.
  2. Select the menu Diagnostics  -> Online Teaching Function  -> Engine Immobiliser  on the Start page.
  3. Select Vehicle  and press . Vehicle data will be read out.
  4. The vehicle identification number (VIN) is displayed. Change the vehicle identification number if necessary.
  5. Enter the repair order number and press .
  6. Enter the PPN user name and password and press .
  7. The Login is performed.
  8. The Tester displays the message Login successful  . Press .
  9. Follow the instructions on the Tester to select the required menu.
  10. Once the teaching process is completed successfully, the Tester shows the following status, for example:

    2 keys taught

    Front BCM: taught

    ELV: taught

    Rear BCM: taught

    DME: taught

    Overall vehicle status: taught

  11. .
  12. Press to exit the Online Teaching Function  and select the Vehicle Type  on the Start page.
  13. Function test: Lock, open and start the vehicle using all remote controls.
  14. Press Read All Fault Memories And Erase If Required  and delete all faults.
scientia non olet · About LEMON Manuals