Removing Bulb For Fog Light

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Position Of Fog Light

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Information

The bulb for the fog light must be removed from below with the vehicle raised.

Release the electric connector using a small screwdriver, for example, and pull it off.

Fig 2: Releasing Electric Connector
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Use a universal pliers to turn the cap/lock in the correct direction (indicated on the lid/bayonet lock) and take it off carefully.

Fig 3: Opening Bulb Lock
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Release the bulb holder -A- and remove it and the cap from its installation position.

Fig 4: Removing Bulb Holder
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Pull off the electric connector -1- on the bulb holder, release the electric connector -2- using a screwdriver and disconnect it.

Fig 5: Disconnecting Connector On Bulb Holder
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Release the locking clip and take the bulb out of the bulb holder.

Fig 6: Removing Bulb From Holder
Courtesy of PORSCHE CARS NORTH AMERICA, INC.