LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2017 >> Macan Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 143 (42 - Rear Wheel Suspension, Drive Shafts -- PANAMERA (970)) >> WM 428855 Replacing Upper Concave Washer (Except PANAMERA Executive, PANAMERA GTS, PANAMERA Turbo S, PANAMERA 4 Executive, PANAMERA Platinum Ed., PANAMERA 4 Platinum Ed.) >> Subsequent Work

Subsequent Work

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2016 Porsche Panamera, 2015 Porsche Panamera, 2014 Porsche Panamera, 2013 Porsche Panamera, and 2012 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.
  1. Clean joint areas and sheetmetal flanges with a wire brush.
  2. Prime joint areas and sheetmetal flanges with 2K primer.
  3. Restore standard seal with body sealant → 5X00IN SEAM SEALING .

    Also seal the repair area carefully.

  4. Paint repair area and adjacent surfaces, if necessary.
  5. Restore standard undersealing with underbody sealant → 5X00IN UNDERBODY PROTECTION .
  6. Apply standard cavity preservation → 5X00IN CAVITY PRESERVATION . Also carefully apply cavity preservation to the repair area.
  7. Install removed accessories in the repair area.

Install rear axle. → 420519 REMOVING AND INSTALLING REAR AXLE HOUSING (CHASSIS SUBFRAME) 

scientia non olet · About LEMON Manuals