LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2017 >> Macan Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 143 (42 - Rear Wheel Suspension, Drive Shafts -- PANAMERA (970)) >> WM 421755 Replacing Bearing For Trailing Arm (Wheel Bearing Housing) (Except PANAMERA Executive, PANAMERA GTS, PANAMERA Turbo S, PANAMERA 4 Executive, PANAMERA Platinum Ed., PANAMERA 4 Platinum Ed.) >> Preliminary Work

Preliminary Work

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2016 Porsche Panamera, 2015 Porsche Panamera, 2014 Porsche Panamera, 2013 Porsche Panamera, and 2012 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise the vehicle → 4X00IN LIFTING THE VEHICLE .

    The next steps must ideally be carried out in parallel.

  2. Remove wheel bearing housing, spreader device (EPB actuator) and brake cover plate. → 425219 REMOVING AND INSTALLING REAR WHEEL BEARING HOUSING  → 468519 REMOVING AND INSTALLING SPREADER DEVICE (EPB ACTUATOR)
    1. 2.1. Loosen axle nut (drive shaft mounting on wheel side). Operate the brake when doing this (a second mechanic is required).
    2. 2.2. Remove spreader device, brake cover plate and then the wheel bearing housing.
scientia non olet · About LEMON Manuals