LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2017 >> Macan Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 143 (42 - Rear Wheel Suspension, Drive Shafts -- PANAMERA (970)) >> WM 420919 Removing And Installing Rear Tie Rod (Toe Control Arm) (Except PANAMERA Executive, PANAMERA GTS, PANAMERA Turbo S, PANAMERA 4 Executive, PANAMERA Platinum Ed., PANAMERA 4 Platinum Ed.) >> Removing And Reinstalling Rear Tie Rod >> Removing Tie Rod

Removing Tie Rod

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2016 Porsche Panamera, 2015 Porsche Panamera, 2014 Porsche Panamera, 2013 Porsche Panamera, and 2012 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.
  1. Mark the position of the toe eccentric adjuster for re-installation.
  2. Due to space restrictions, the top front control arm on the outside of the wheel carrier must be removed in order to access the tie rod on the right side of the vehicle. → 423555 REPLACING UPPER CONTROL ARM (REAR AXLE) 
  3. Release tie rod -2-  from the chassis subframe (eccentric screw) and from the wheel carrier -1-  .
  4. Remove tie rod -2-  .
    Fig 1: Identifying Tie Rod And Wheel Carrier
    G09807554Courtesy of PORSCHE CARS NORTH AMERICA, INC.
scientia non olet · About LEMON Manuals