LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2017 >> Macan Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 143 (42 - Rear Wheel Suspension, Drive Shafts -- PANAMERA (970)) >> WM 420855 Replacing Bearing For Rear Axle (Except PANAMERA GTS, PANAMERA Turbo S, PANAMERA Platinum Ed., PANAMERA 4 Platinum Ed.) >> Preliminary Work

Preliminary Work

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2016 Porsche Panamera, 2015 Porsche Panamera, 2014 Porsche Panamera, 2013 Porsche Panamera, and 2012 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise the vehicle. → 4X00IN LIFTING THE VEHICLE
  2. On vehicles with levelling system: Bleed the system at the rear axle or at the relevant air spring using the Porsche System Tester. → 4301IN BLEEDING AND FILLING THE LEVELLING SYSTEM
  3. Remove the relevant wheel. → 440519 REMOVING AND INSTALLING WHEEL
  4. Remove wheel housing liner. → 536919 REMOVING AND INSTALLING REAR WHEEL HOUSING LINER
  5. On vehicles with steel springs: Relieve the relevant steel spring. → 427219 REMOVING AND INSTALLING REAR COIL SPRING 
  6. Remove the relevant center protective plate at the left/right. → 519319 REMOVING AND INSTALLING COVER FOR CENTRE UNDERBODY
  7. Remove rear protective plate. → 519419 REMOVING AND INSTALLING COVER FOR REAR UNDERBODY
  8. Remove cross strut (W-strut). → 421319 REMOVING AND INSTALLING REAR-AXLE CHASSIS SUBFRAME STRUTS 
  9. For rear RA chassis subframe bearings:
    1. 9.1. Remove rear silencer. → 260119 REMOVING AND INSTALLING EXHAUST SYSTEM
    2. 9.2. Partly remove rear anti-roll bar. In other words: Suspend the anti-roll bar on the connecting links. → 429019 REMOVING AND INSTALLING REAR ANTI-ROLL BAR   →  429019 REMOVING AND INSTALLING REAR ANTI-ROLL BAR (PDCC)  
scientia non olet · About LEMON Manuals