Replacing Control Unit For Front-End Electronics

Information 

All remote controls (keys) are required for teaching a DME, front-end electronics (front BCM), rear-end electronics (rear BCM), electronic steering lock (ELV) control unit or remote controls (keys) for example.

Remote controls (keys) that are not taught during this teaching procedure will no longer be recognised by the vehicle.

→ Prior to disconnecting the control unit, switch off ignition and remove ignition key.

→ Ensure that the power supply is not interrupted during programming.

→ Connect a battery charger with a current rating of at least → Nominal value: 40 A  to the vehicle battery.

Information 

The PIWIS Tester II 9818  instructions take precedence since the description may be different with later Tester releases.

The procedure described here has been structured in general terms; different text or additions may appear in PIWIS Tester II 9818  .

1. PIWIS Tester II 9818  must be connected to the vehicle before starting the Tester. Switch on ignition using original remote control.
2. Select the vehicle type.
3. Select Front-end electronics  using the cursor keys and press [>>].
4. Select Control unit replacement  with the cursor keys and press the [>>] key.
5. Select Read out values  (vehicle data) with the cursor keys and press [>>].
6. The message Values were read out  appears on the Tester screen.
7. Switch off ignition and replace the control unit. → 944919 REMOVING AND INSTALLING CONTROL UNIT FOR FRONT-END ELECTRONICS .
8. Go back to the Start page on the Tester
9. To activate the control units, switch on the hazard warning lights.
10. Select the Online teaching function  menu on the Start page.
11. Select Vehicle  and press [>>]. Vehicle data will be read out.
12. The vehicle identification number (VIN) is displayed. Adapt the vehicle identification number if necessary.
13. Enter the repair order number and press [>>].
14. Enter the PPN user name and password and press [>>].
15. Login is performed.
16. The Tester displays the message Login successful  . Press [>>].
17. Follow the instructions on the Tester to select the required menu.
18. Once the teaching process is completed successfully, the Tester shows the following status, for example:

    2 keys taught

    Front BCM: taught

    ELV: taught

    Rear BCM: taught

    DME: taught

    Overall vehicle status: taught

19. [>>].
20. Press EXIT to exit the Online teaching function  and select the vehicle type  on the Start page.
21. Select Front-end electronics  using the cursor keys and press [>>].
22. Select Control unit replacement  with the cursor keys and press the [>>] key.

    Re-install the data that was read out by selecting Write values  .

23. Press [F7] Read all fault memories and erase if required  and delete all faults.
24. Function test: Lock, open and start the vehicle using all remote controls.
25. Read out fault memory.