| Lower trailing arm to rear axle housing |
M12 thread/always use new screws or bolts and nuts following removal |
Initial tightening |
70 Nm (52 ftlb.) |
|
|
| Lower trailing arm to rear axle housing |
M12 thread/always use new screws or bolts and nuts following removal |
Final tightening |
+180° |
|
|
| Lower trailing arm to wheel bearing housing |
M14 thread/always use new screws or bolts and nuts following removal |
Initial tightening |
120 Nm (89 ftlb.) |
|
|
| Lower trailing arm to wheel bearing housing |
M14 thread/always use new screws or bolts and nuts following removal |
Final tightening |
+360° |
|
|
| Level sensor to lower trailing arm |
M6 x 16 thread |
Tightening torque |
9 Nm (6.5 ftlb.) |
|
|
| Connecting link to lower trailing arm |
M10 x 65 thread/always use new screws or bolts following removal |
Initial tightening |
40 Nm (30 ftlb.) |
|
|
| Connecting link to lower trailing arm |
M10 x 65 thread/always use new screws or bolts following removal |
Final tightening |
+90° |
|
|