Programming/Teaching Roof Assembly (Panorama Roof) End Position
Information
NOTE:
The end positions are lost and must be re-taught in the following situations:
- After disconnecting or connecting the vehicle battery
- When the vehicle battery is completely flat or after jump-lead starting
- After emergency operation
- After changing the electric fuse
- After replacing the glass panel, motor, powered sunroof mechanism or sun blind
CAUTION:
Electrically moved components
- Risk of damage to components
→ Move objects out of the range of movement.
The force limiters are not available when storing the end positions. The panorama roof and sun blind therefore close with full force!
- Park the vehicle and start the engine.NOTE: When storing the end positions, always save the settings for the panorama roof and sun blind fully one after the other. If one of the processes is interrupted, it is not possible to start the process for the other drive mechanism.
- Press the actuating button for the panorama roof forward towards Close and keep it pressed until the panorama roof is closed fully and has stopped moving. The process for storing the end position will start after approx. 10 seconds.
- Press the actuating button for the sun blind forward towards Close and keep it pressed until the sun blind is closed fully and has stopped moving. The process for storing the end position will start after approx. 10 seconds.
- Check that the panorama roof and sun blind operate correctly.