LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2017 >> Macan Base >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> 53 - Body Rear - (95B) - MACAN S >> WM 534855 Replacing Rear Side Member >> Preparing Rear Side Member For Installation

Preparing Rear Side Member For Installation

  1. Fit in rear side member.
  2. Prepare rear side member for bonding and blind rivets.
    1. 2.1. Prepare for bonding in the area shown and drill out the holes for a blind rivet joint fully. → Diameter: 6.5 mm 
      G12893288Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  3. Prepare rear side member for bonding and welding.
    1. 3.1. Drill holes for plug welding in the marked areas -A-  on the rear side member. → Diameter: 8.0 mm 
      G12893289Courtesy of PORSCHE CARS NORTH AMERICA, INC.
      G12893290Courtesy of PORSCHE CARS NORTH AMERICA, INC.
      G12893291Courtesy of PORSCHE CARS NORTH AMERICA, INC.
      G12893292Courtesy of PORSCHE CARS NORTH AMERICA, INC.
    Green Resistance spot-welding + bonding
    Red Plug-welding/apply a full weld using inert gas without bonding
    Orange Resistance spot-welding
scientia non olet · About LEMON Manuals