Removing Dashboard Inset

1. Move steering column to its lowest, rearmost position.
2. Unclip bottom of dashboard inset -1-  at the left, right and in the middle from the dashboard using a plastic wedge -2-  .
3. Unscrew fastening screws -1-  and remove plastic insulating plates -2-  between dashboard inset -3-  and dashboard.
4. Loosen dashboard inset at top and detach it from the dashboard.
   1. 4.1. Carefully push a plastic squeegee -1-  in between the top of the dashboard inset -2-  and dashboard and loosen top of dashboard inset in area -a-  .
5. Remove dashboard inset at the top -1-  .
   1. 5.1. Position a plastic squeegee -2-  and plastic wedge -3-  close to the fastening pins -a-  between the top of the dashboard inset and the dashboard.
   2. 5.2. Disengage fastening pins -a-  at the left and right by pulling them horizontally to the rear.
   3. 5.3. Remove dashboard inset at the top.

Removing dashboard inset at the top