Subsequent Work For Right Spring Strut (Air Springs)

If installed:
Install torque support.

> 103719 REMOVING AND INSTALLING TORQUE SUPPORT
On vehicles with petrol engine:
Clip in bleeder valve -1- at the coolant reservoir.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Clipping in wire harness at right of engine compartment
On vehicles with petrol engine:
Clip in plug connections -2, 3- at the holders at the cross panel.
On vehicles with diesel engine:
Install fuel filter holder -1, 5- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Fuel filter holder
1. 4.1 Install holder -5- .
2. 4.2 Tighten nuts -6- . > Tightening torque 8 (6 ftlb.) Nm
3. 4.3 Install holder -1- .
4. 4.4 Tighten fastening screw -3- . > Tightening torque 8 (6 ftlb.) Nm
5. 4.5 Tighten nuts -2- . > Tightening torque 8 (6 ftlb.) Nm
6. 4.6 Clip in electric plug connection -4- .
On vehicles with diesel engine:
Install fuel filter.

> 206019 REMOVING AND INSTALLING FUEL FILTER
Fit drive shaft.
> 404119 REMOVING AND INSTALLING FRONT DRIVE SHAFT
Fit the relevant side engine compartment trim.
> WM 700219 REMOVING AND INSTALLING FRONT TRIM PANEL (ENGINE COMPARTMENT) (CAYENNE, CAYENNE GTS, CAYENNE TURBO S, CAYENNE S, CAYENNE S E-HYBRID, CAYENNE TURBO, CAYENNE S DIESEL, CAYENNE (3.0))
To fill the air suspension (the system must be filled with compressed air), use the Porsche System Tester.
> 4301IN FILLING SPECIFICATION FOR AIR-SPRING STRUT
Switch on the levelling system
> LIFTING THE VEHICLE