Installing Vacuum Line For Brake Booster
WARNING: This page is about a different car, the 2014 Porsche Cayenne, 2013 Porsche Cayenne, 2012 Porsche Cayenne, and 2011 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.
- Carefully guide the vacuum line into the plenum panel from the right.
- Clip the vacuum line -1-
into the retaining clip -2-
in the plenum panel.
Clip on brake booster vacuum line
- Plug in electric plug connection -1-
for the vacuum control valve -2-
(-A-
) and lock it -a-
.
Electric plug connection on vacuum control valve
Information
The two O-rings on the vacuum line at the vacuum pump must always be replaced.
- Fit vacuum line -2-
for brake booster onto the vacuum pump -3-
and secure the clamp -1-
.
Vacuum pump line
- Carefully press the vacuum line -1-
with the rubber boot -2-
into the bulkhead -3-
.
Rubber boot on vacuum line for brake booster
- Carefully fit the vacuum line -1-
into the brake booster -2-
.
Vacuum line on brake booster (shown without brake master cylinder)