Installing Rear Brake Calliper
WARNING: This page is about a different car, the 2014 Porsche Cayenne, 2013 Porsche Cayenne, 2012 Porsche Cayenne, and 2011 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Old mounting parts fitted on the brake calliper
- Reduced braking effect
- Risk of damage to the brake calliper
- Fit new fastening screws
The brake calliper is installed in reverse order.
Information
- Replace screws.
- Never use an impact bolter to loosen and tighten the brake calliper on the wheel carrier.
- Observe correct tightening torques
> 4X00IN TIGHTENING TORQUES FOR BRAKE HYDRAULICS
- Check that all parts are in perfect condition (visual inspection) and replace them if necessary.
- Fit the brake calliper.
Information
- Make sure that the brake line is not twisted. A twisted brake line can damage the bellows at the drive shaft while driving.
- Fit the brake line to the brake calliper.
- Fit the holder for the brake pad wear indicator cable and for the brake line to the brake calliper.
- Clip in the connector for the brake pad wear indicator.
- Position disc brake pads by operating the brake several times.