Subsequent Work For Removing And Installing Spreader Device (Epb)
WARNING: This page is about a different car, the 2014 Porsche Cayenne, 2013 Porsche Cayenne, 2012 Porsche Cayenne, and 2011 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.
- Install brake shoes.
> 468356 Replacing brake shoes - section on "INSTALLING "
- Fit the brake calliper.
> 474119 Removing and installing rear brake calliper - section on "INSTALLING "
Information
If new brake discs and/or new brake shoes are installed on the vehicle, they must be worn in before calibration (not PCCB!).
> WM, 468350 GRINDING DOWN PARKING-BRAKE SHOES (EPB)
If a new actuator was installed, it must be confirmed in the Porsche System Tester.
- >>Control unit overview<<>>Parking brake<<>>Drive links/Tests<<>>Confirm actuator replacement<<.
- Adjust and calibrate the parking-brake shoes.
>468316 ADJUSTING AND CALIBRATING PARKING-BRAKE SHOES
Grind down the parking-brake shoes during adjustment and calibration if necessary.