Installing Rear Brake Disc
WARNING: This page is about a different car, the 2014 Porsche Cayenne, 2013 Porsche Cayenne, 2012 Porsche Cayenne, and 2011 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.
Information
- Brake calliper screws can always be re-used if no damage can be identified.
- Replace damaged bolts.
- Observe different tightening specifications!
Do not confuse right and left brake discs during assembly!
Distinguishing feature: Part No.!
- Check that all parts are in perfect condition (visual inspection) and replace them if necessary.
- Clean the levelling and centering surfaces on the brake disc and wheel hub.
- Apply a very thin coat of Optimoly TA to the centering surface on the wheel hub.
- Fit brake disc. Observe the correct tightening torque.
- Fit the brake calliper. Observe the correct tightening torque.
- Guide and insert the plug connection for the brake pad wear indicator into the holder.
- Position disc brake pads by operating the brake several times.
- Check the brake fluid level and correct it if necessary.