LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2017 >> Cayenne Turbo >> Repair and Diagnosis >> External Pages >> Different car >> Section 88 (46 - Brakes - Brake Mechanism (4.8L Non Turbo) -- 92A - Cayenne (92A)) >> WM, 461019 Removing And Installing Mounting Saddle >> Removing Mounting Saddle

Removing Mounting Saddle

WARNING: This page is about a different car, the 2014 Porsche Cayenne, 2013 Porsche Cayenne, 2012 Porsche Cayenne, and 2011 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.
G16330210Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Installation position of mounting saddle

  1. Remove the relay carrier at the right -2-  next to the brake pedal.
    G16330211Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Removing relay carrier

    1. 1.1 Loosen the fastening screw -1-  on the relay carrier -2-  at the right next to the brake pedal.
    2. 1.2 Pull the relay carrier down and to the rear -A-  and remove it from the lower guide.
    3. 1.3 Pull the top guide -3-  for the relay carrier up -B-  out of the bracket -4-  on the mounting saddle.
  2. Loosen the fastening nuts -1-  on the brake booster under the dashboard.
    G16330212Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Removing brake booster

  3. Unclip cable duct cover from main wire harness against the direction of travel -arrow-  and cut the tie-wraps (three in cable duct and three on the left of the cable duct).
    G16330213Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Opening cable duct

  4. Unclip the fixing clips -1-  from the cable duct -2-  on the mounting saddle using a suitable tool, e.g. pointed-nose pliers.
    G16330214Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Clips on cable duct

  5. Loosen the top fastening screws -1-  for the mounting saddle in the plenum panel.
    G16330215Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Fastening screws for mounting saddle at the top

  6. Fit the fastening screw -1-  for the mounting saddle at the bottom in the plenum panel, under the brake booster.
    G16330216Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Fastening screw for mounting saddle in plenum panel at the bottom

  7. Loosen the fastening screws -1-  for the heat shield -2-  at the left of the primary catalytic converter on the longitudinal member.
    G16330217Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Heat shield, left

  8. Unscrew the bottom fastening screw -1-  for the mounting saddle through the opening in the wheel housing.
    G16330218Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Fastening screw for mounting saddle at the bottom

  9. Remove mounting saddle from the vehicle.
scientia non olet · About LEMON Manuals