LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2017 >> Cayenne Turbo >> Repair and Diagnosis >> External Pages >> Different car >> Section 88 (46 - Brakes - Brake Mechanism (4.8L Non Turbo) -- 92A - Cayenne (92A)) >> WM, 461019 Removing And Installing Mounting Saddle >> Installing Mounting Saddle

Installing Mounting Saddle

WARNING: This page is about a different car, the 2014 Porsche Cayenne, 2013 Porsche Cayenne, 2012 Porsche Cayenne, and 2011 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.
  1. Fit mounting saddle in the vehicle.
  2. Fit fastening screw -1-  at the bottom.
    G16330219Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Fastening screw for mounting saddle at the bottom

  3. Fit fastening screws -1-  for the heat shield -2-  at the left of the longitudinal member.
    G16330220Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Heat shield, left

  4. Fit the fastening screw -1-  for the mounting saddle at the left under the brake booster.
    G16330221Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Fastening screw for mounting saddle in plenum panel at the bottom

  5. Fit the top fastening screws -1-  for the mounting saddle in the plenum panel.
    G16330222Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Fastening screws for mounting saddle at the top

  6. Pre-fit tie-wraps -1-  in the cable duct -2-  .
    G16330223Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Pre-fitting tie-wraps in cable duct

  7. Clip in fixing clips -1-  from the cable duct -2-  at the mounting saddle.
    G16330224Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Clips on cable duct

  8. Secure main wire harness in the cable duct using the tie-wraps and then clip on the cable duct cover.
    G16330225Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Main wire harness in cable duct

  9. Secure main wire harness on cable duct.
    G16330226Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Main wire harness at the side of the cable duct

  10. Fit the fastening nuts -1-  for the brake booster under the dashboard.

    > 4X00IN TIGHTENING TORQUES FOR BRAKE MECHANISM

    G16330227Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Fitting brake booster

  11. Fit the relay carrier.
    G16330228Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Fit relay carrier at the right

    1. 11.1 Insert the guide -3-  for the relay carrier at the right next to the brake pedal from above -B-  and into the holder -4-  .
    2. 11.2 Press the relay carrier -2-  down into the guide -A-  .
    3. 11.3 Fit the fastening screw -1-  .
scientia non olet · About LEMON Manuals