Installing Brake Pedal

WARNING: This page is about a different car, the 2014 Porsche Cayenne, 2013 Porsche Cayenne, 2012 Porsche Cayenne, and 2011 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.

Information

Do not grease or spray the brake pedal shaft (pin).
For vehicles with automatic transmission a spacer tube is used instead of the clutch pedal.
Use new lock nuts.
Observe correct tightening torques
> "Technical values"
Tightening torque for brake pedal shaft (pin): 15 ± 2 ftlb.

Insert the brake pedal into the vehicle.
Press the brake pedal shaft -1- fully into the brake pedal -1- (-arrow- ).

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Pressing in brake pedal shaft
When sliding in the brake pedal shaft -1- , ensure that the cut-out -2- on the brake pedal shaft fits into the guide -3- on the holder -4- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Positioning brake pedal shaft
Slide the lock -1- at the left onto the brake pedal shaft -2- (-arrow- ).

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Fitting brake pedal lock
Position the brake pedal -1- on the push rod -2- for the brake booster.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Brake pedal on push rod
Press the brake pedal -1- through fully -arrow- until the push rod -2- clicks into place in the holder -3- on the brake pedal.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Fitting brake pedal
Position crash support -2- on the brake pedal.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Crash support

Fit fastening screw -1- for crash support -2- .

> 4X00IN TIGHTENING TORQUES FOR BRAKE MECHANISM