LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2017 >> Cayenne Turbo >> Repair and Diagnosis >> External Pages >> Different car >> Section 87 (42 - Rear Wheel Suspension Drive Shaft (4.8L Non Turbo) -- 92A - Cayenne (92A)) >> WM, 429019 Removing And Installing Anti-Roll Bar >> Preliminary Work

Preliminary Work

WARNING: This page is about a different car, the 2014 Porsche Cayenne, 2013 Porsche Cayenne, 2012 Porsche Cayenne, and 2011 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: Wheel bearing housing raised incorrectly 
  • Risk of crushing 
  • Risk of damage to components 
    1. Wear personal protective gear.
    2. Do not raise the wheel suspension higher than the normal vehicle position (vehicle resting on wheels).
  1. Raise the vehicle at the jacking points provided for this purpose.

    > WM, 4X00IN LIFTING THE VEHICLE

  2. Remove the rear right wheel.

    > 440519 Removing and installing wheel - section on "REMOVING "