LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2017 >> Cayenne Turbo >> Repair and Diagnosis >> External Pages >> Different car >> Section 87 (42 - Rear Wheel Suspension Drive Shaft (4.8L Non Turbo) -- 92A - Cayenne (92A)) >> WM, 425219 Removing And Installing Wheel Bearing Housing >> Subsequent Work >> Reworking

Subsequent Work: Reworking

WARNING: This page is about a different car, the 2014 Porsche Cayenne, 2013 Porsche Cayenne, 2012 Porsche Cayenne, and 2011 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.
  1. Perform the basic brake shoe adjustment and calibrate the electric parking brake actuators.

    > 468316 ADJUSTING AND CALIBRATING PARKING-BRAKE SHOES

  2. Connect level sensor to front upper control arm.

    > 431955 Replacing rear level sensor - section on "INSTALLING "

    Make sure that the level sensor linkage is pointing outwards.

  3. Mount the wheel.

    > 440519 Remove and install wheel - section on "INSTALLING "

  4. Tighten the axle nut (drive shaft mount on wheel side) (2nd step!). Activate the brake while doing this (2nd mechanic required).

    > Tightening torque 460 Nm (339.3 ftlb.)

  5. For vehicles with air suspension: 

    Fill air springs.

    > 4301IN BLEEDING AND FILLING THE LEVELLING SYSTEM

  6. Align suspension.

    > Complete suspension alignment