LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2017 >> Cayenne Turbo >> Repair and Diagnosis >> External Pages >> Different car >> Section 87 (42 - Rear Wheel Suspension Drive Shaft (4.8L Non Turbo) -- 92A - Cayenne (92A)) >> WM, 422119 Removing And Installing Rear Drive Shaft >> Subsequent Work

Subsequent Work

WARNING: This page is about a different car, the 2014 Porsche Cayenne, 2013 Porsche Cayenne, 2012 Porsche Cayenne, and 2011 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.
  1. Adjust the brake shoes to their basic setting and calibrate the electric parking brake actuators.

    > 468316 ADJUSTING AND CALIBRATING PARKING-BRAKE SHOES

  2. Connect the level sensor to the front upper wishbone.

    > 431955 Replacing rear level sensor - section on "INSTALLING "

    Make sure that the level sensor linkage is facing outwards.

  3. Fit the wheel.

    > 440519 Removing and installing wheel - section on "INSTALLING "

  4. Tighten axle nut (drive shaft mounting on wheel side) (2-step tightening procedure!). Operate the brake while doing this (2 mechanics required).

    > WM, 4X00IN TIGHTENING TORQUES FOR REAR AXLE

  5. For vehicles with air suspension: 

    Fill the air springs.

    > 4301IN BLEEDING AND FILLING THE LEVELLING SYSTEM

  6. Perform suspension alignment.

    > Suspension alignment, complete