LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2017 >> Cayenne Turbo >> Repair and Diagnosis >> External Pages >> Different car >> Section 87 (42 - Rear Wheel Suspension Drive Shaft (4.8L Non Turbo) -- 92A - Cayenne (92A)) >> WM, 422119 Removing And Installing Rear Drive Shaft >> Preliminary Work

Preliminary Work

WARNING: This page is about a different car, the 2014 Porsche Cayenne, 2013 Porsche Cayenne, 2012 Porsche Cayenne, and 2011 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.
  1. Move electric parking brake (EPB) into >>installation position<< using the Porsche System Tester. To do this, select >>Parking brake<< in the control unit overview. Select >>Drive link tests<<>>All<<>>Move to installation position<<.
  2. Loosen axle nut (drive shaft mounting on wheel side). (Do not remove it!) This prevents the drive shaft from slipping out when removing the wheel bearing housing. Actuate the brake while doing this.
  3. Remove the wheel.

    > 440519 Removing and installing wheel - section on "REMOVING "

  4. Remove rear level sensor from the front upper wishbone.

    > 431955 REPLACING REAR LEVEL SENSOR - section on "Removing"

scientia non olet · About LEMON Manuals