LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2017 >> Cayenne Turbo >> Repair and Diagnosis >> External Pages >> Different car >> Section 87 (42 - Rear Wheel Suspension Drive Shaft (4.8L Non Turbo) -- 92A - Cayenne (92A)) >> WM, 421119 Removing And Installing Lower Trailing Arm >> Removing Trailing Arm

Removing Trailing Arm

WARNING: This page is about a different car, the 2014 Porsche Cayenne, 2013 Porsche Cayenne, 2012 Porsche Cayenne, and 2011 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.
  1. Loosen the threaded joint -1-  for the trailing arm -2-  on the wheel bearing housing -3-  and pull out the screw.
    G16329791Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Fastening screw on wheel bearing housing

  2. Mark the installation position of the eccentric screw -1-  in the rear axle housing -2-  (-A-  ).
    G16329792Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Marking position of eccentric screw

  3. Loosen the eccentric screw -1-  for the trailing arm -2-  and pull it out of the rear axle housing -3-  .
    G16329793Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Eccentric screw for trailing arm

  4. Loosen the fastening screw -1-  for the trailing arm -2-  in the front rear axle housing -3-  and pull it out.
    G16329794Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Front fastening screw

  5. Take the trailing arm out of the vehicle.

    Press it out of the guides using a suitable tool if necessary.

scientia non olet · About LEMON Manuals