LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2017 >> Cayenne Turbo >> Repair and Diagnosis >> External Pages >> Different car >> Section 87 (42 - Rear Wheel Suspension Drive Shaft (4.8L Non Turbo) -- 92A - Cayenne (92A)) >> WM, 420119 Removing And Installing Rear Axle >> Installing Rear Axle

Installing Rear Axle

WARNING: This page is about a different car, the 2014 Porsche Cayenne, 2013 Porsche Cayenne, 2012 Porsche Cayenne, and 2011 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: Moving components 
  • Danger of limbs being trapped or severed 
    1. Do not reach into the danger area.
    2. Secure the system to prevent it from being activated accidentally.
    3. Keep third parties away from the danger area.
  1. Installation is performed in reverse order.

    > WM, 4X00IN TIGHTENING TORQUES FOR REAR AXLE

  2. Position the rear axle housing back in its original, marked installation position and tighten it.
    G16329767Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Marking rear axle housing

  3. Replace circlip at the input flange of the rear final drive.
    G16329768Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Circlip

  4. Position the cardan shaft at the marking on the rear final drive.
    G16329769Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Marking installation position of cardan shaft

  5. For vehicles with PDCC (Porsche Dynamic Chassis Control - anti-roll stabilisation): 

    On vehicles with PDCC, the lines (pressure line, return line) at the PDCC valve block must be fitted from rear axle to front axle.

scientia non olet · About LEMON Manuals