LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2017 >> Cayenne Turbo >> Repair and Diagnosis >> External Pages >> Different car >> Section 86 (40 - Wheel Suspension Front Drive Shaft (4.8L Non Turbo) -- 92A - Cayenne (92A)) >> WM, 407819 Removing And Installing Front Connecting Link >> Removing Front Connecting Link

Removing Front Connecting Link

WARNING: This page is about a different car, the 2014 Porsche Cayenne, 2013 Porsche Cayenne, 2012 Porsche Cayenne, and 2011 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: Wheel bearing housing raised incorrectly 
  • Risk of crushing 
  • Risk of damage to components 
    1. Wear personal protective gear.
    2. Do not raise the wheel suspension higher than the normal vehicle position (vehicle resting on wheels).
  1. Only for 19-inch brake system: 

    Remove air guide.

    > 407719 REMOVING AND INSTALLING FRONT ANTI-ROLL BAR (PDCC)  - section on "Removing"

  2. Raise the vehicle.
  3. Loosen the bottom fastening screw -2-  on the connecting link -5-  .
    G16329449Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Front connecting link

  4. Raise the lower axle support -3-  as far as required using a suitable jack -4-  so that the upper fastening screw -1-  on the connecting link can be loosened and removed easily.
  5. Remove the connecting link -5-  .
scientia non olet · About LEMON Manuals