Installing Front Connecting Link
WARNING: This page is about a different car, the 2014 Porsche Cayenne, 2013 Porsche Cayenne, 2012 Porsche Cayenne, and 2011 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.
Information
Dimension -X- : lower edge of wing to centre of axle (shown as an example)
- All screws and bolts on the axle must be tightened in vehicle position. Vehicle position means: vehicle resting on its wheels, or the wheel suspension is lifted with a universal jack. -Dimension X- from lower edge of wing to centre of axle corresponds to vehicle position. For the current height values, please refer to the adjustment values for suspension alignment
- Visually inspect all parts.
- Replace self-locking nuts.
- Replace all expansion screws (screws fitted using torque angle tightening procedure).
- Use correct tightening torques and torque angle.
> Refer to the appropriate Tightening Torques For Front Axle service information
- Raise the lower axle support -3-
as far as required using a suitable jack -4-
so that the upper fastening screw -1-
on the connecting link can be fitted easily.
Front connecting link
- Fit the bottom fastening screw -2- for the connecting link -5- on the anti-roll bar.
- Fit the fastening screws for the connecting link.
> Refer to the appropriate Tightening Torques For Front Axle service information
- 19-inch wheels only:
Fit the air guide.
> 407719 REMOVING AND INSTALLING FRONT ANTI-ROLL BAR (PDCC) - section on "Installing"